Разработка на базе 3d принтера автоматизированного комплекса по установке, фиксации и прихватке крепёжных элементов сварных конструкций (приварок) для закрепления изделий приборостроения

Abstract

This article contains the development of the design of the layout of the installation mechanism, fixing and welding of welding structures. The main design parameters were taken from analysis of previous works. At the moment, work continues by students, laboratory assistants and teachers of the CITAM department to create this automated complex. In the future, the main task will be the creation of an automated complex based on a manipulator for higher performance, convenience and ease of use.